Hitachi 46F510 Service Manual page 128

CAUTIONS WHEN CONNECTI NG/DIS CONNECTING THE HV CONNECTOR
During Removal
1. Roll out "@silicon cover from FBT's
contact area slowly.
2. While turnin g the connector about
"@90 degrees following the arrow
Silicon cover
(0 position). Push the conn ector
slightly towards the case. (Fig.A)
wing
L position
PS process
Çn
During Insertion
1. Please refer to direction fo r insertion as s
(L position) Insert connecto r till $ C LICK$ sound is heard.
2. Make sure the connector is pr essed right in,
has a good contact with th e spring.
Fig. A
3. Confirm the co ntact by pulling the connector
3. Remove the connector slowly by (Don't pull hard because it m ay damage the connector.)
pulling it awa y from the case . 4. Cover the high voltage outpu t by carefully pu
silicon cover on to it. (Don't turn the conn
(REMARK)
1. Make sure the silicon cover is
covered the h igh voltage output.
WIRING DRAWING
(UFPK) FOCUS PACK ASY.
PAING EACH COLOR
BLUE
CONNECT EACH COLOR
SCREEN LEAD FROM CPT P.W.B.
LEAD COLOR:ORANDE
wing CONNECT EACH COLOR
FOCUS LEAD FROM CPT P.W.B.
LEAD COLOR:IVORY
L position
CONNECT[FS]CONNECTOR
FROM FBT.
Fig.B FOCUS PACK
BACK SIDE
hown in Fig.B
so that it
WRAPPING & SOLDER
slightly.
(DF)CONNECTOR BLACK
shing
ector.)
(DF)CONNECTOR RED
Silicon Cover
(NFP1)UL TUBE No.3 L=50mm
(NFP2)SK BINDER
less than 1mm
F.B.T
128
NOTE:(2) CPT SOCKET HOLDER ASSEMBLY.(R.G.B)
CPT SOCKET HOLDER ASSEMBLY SHOULD
BE FOLLOWE D BELOW FIG.
#234
CPT SOCKET
RED
GREEN "@
HOLD BAND
BLUE GREEN "@ RED
#231
PAINT EACH COLOR
CPT SOCKET HOLDER
DP33KA/B