Hardware - Ezgo 2012 TERRAIN 250 Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

Hardware

BOLT SIZE
Grade 2
Grade 5
Grade 8
5
BOLT SIZE
Class 5.8
(Grade 2)
5.8
Class 8.8
8.8
(Grade 5)
Class 10.9
10.9
(Grade 8)
Periodically, the vehicle should be inspected for loose fasteners. Fasteners should be tightened in accordance with
the Torque Specifications table.
Use care when tightening fasteners and refer to the Technician's Repair and Service Manual for specific torque val-
ues.
Generally, three classes of standard hardware and two classes of metric hardware are used in the vehicle. Grade 5
hardware can be identified by the three marks on the hexagonal head and grade 8 hardware is identified by 6 marks
on the head. Metric hardware is marked on the head with 8.8 or 10.9. Unmarked hardware is Grade 2.
5 - 12
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
1/4" 5/16" 3/8" 7/16"
4 8 15
(5) (11) (20)
6 13 23
(8) (18) (31)
6 18 35
(8) (24) (47)
M4 M5 M6
1 2 4
(2) (3) (6)
2 4 7
(3) (6) (10)
3 6 10
(4) (8) (14)
Torque Specifications and Bolt Grades
1/2" 9/16"
24 35 55
(33) (47) (75) (102)
35 55 80
(47) (75) (108) (149)
55 80 110
(75) (108) (149) (230)
M8 M10 M12 M14
10 20 35
(14) (27) (47) (76.4)
18 35 61
(24) (47) (83) (131)
25 49 86
(34) (66) (117) (184)
5/8" 3/4" 7/8"
75 130 125 190
(176) (169) (258)
110 200 320 480
(271) (434) (651)
170 280 460 680
(380) (624) (922)
55
97
136
1"