Ezgo 2012 TERRAIN 250 Owner's Manual page 36

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
charging. Never charge a frozen battery. Study all battery manufacturers' specific precautions
such as recommended rates of charge and removing or not removing cell caps while charging.
Portable chargers must be mounted on a platform above the ground or in such a manner as to
permit the maximum air flow underneath and around the charger.
Portable chargers are shipped with the vehicles. Prior to vehicle or charger operation, the charger must be removed
and mounted on a platform or wall above the ground to permit maximum air flow around and underneath the charger. A
dedicated circuit is required for the charger. Refer to the charger manual for appropriate circuit protection. For
optimum performance and shortest charge times, place the charger in an area with adequate ventilation. The charger
4 should also be placed in an area that will be relatively free of dirt, mud, or dust since accumulations within the fins of the
charger will reduce their heat-dissipating qualities. Optimal cooling also occurs when the charger is placed on a
horizontal surface with the fins vertical. More airflow from below the charger will help cool the fins, so placement above
open areas or areas with cut-outs for airflow is desirable. If the charger is operated in an outdoor location, rain and sun
protection must be provided. The charger may get hot during operation and must be placed such that risk of contact by
people is reduced. The charger may be mounted on a wall or shelf using #10-M5 screws. The charger's status display
must be visible to the user.
Provide Protection From Elements
Keep cooling fins clean and free of dirt and debris
NEMA 15 - 5R Grounded AC Receptacle
110 - 120 VAC. Dedicated 15 AMP Circuit
Locations outside the US and Canada: Reference
appropriate local electrical code and charger manu-
facturer recommendations for AC power requirements
4 - 4
Mounting Holes
Charger Installation