Declaration Of Conformity; Troubleshooting - Bosch AMW SG Original Instructions Manual

OBJ_BUCH-1676-001.book Page 11 Friday, June 29, 2012 8:23 AM
Technical Data
Pole Pruner Attachment
Article number
Chain bar length
Chain speed (no-load)
Chain, width
Oil tank volume
Weight according to
EPTA-Procedure 01/2003
without power unit
Serial number

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical data" is in conformity with the fol-
lowing standards or standardization documents: EN 60335
according to the provisions of the directives 2006/95/EC,
2004/108/EC, 2006/42/EC, 2000/14/EC.
2000/14/EC: Guaranteed sound power level 107 dB(A).
Equipment category: 25
Technical file (2006/42/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS,
Stowmarket, Suffolk IP14 1EY, England
Dr. Egbert Schneider Helmut Heinzelmann
Senior Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, garden tools Division
D-70745 Leinfelden-Echterdingen
22.06.2012

Troubleshooting

Problem Possible Cause
Saw chain dry No oil in reservoir
Oil passage clogged
Saw chain/guide bar hot No oil in reservoir
Chain tension too high
Dull saw chain
Pole Pruner rips, vibrates, Chain tension too loose
does not saw properly
Dull saw chain
Chain worn out
Chain teeth are facing in the wrong direction Reassemble with chain in correct direction
Too much force applied
Saw chain/guide bar hot No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain tension too high
Dull saw chain
Bosch Power Tools
Noise/Vibration Information
The following information is applicable for the attachment op-
AMW SG
erated by the power unit:
0 600 8A3 B..
Measured sound values determined according to
mm 300
EN ISO 11680.
m/s 12
Typically the A-weighted noise levels of the product are:
mm 1.3
Sound pressure level 84.5 dB(A); sound power level
ml 150 104.5 dB(A). Uncertainty K =2.5 dB.
Vibration total values (triax vector sum): Vibration emission
value a
kg 1.55
Mounting and Operation
see type plate on the gar-
den product
Action
Delivery Scope
Open cover
Assemble / tension saw chain
Fitting the multi-tool attachmentt
Filling oil
Working Advice
Storage
Selecting accessories
Unfasten the locking knob on cover.
Turn the chain locking screw in housing next to the chain bar
clockwise to tension and anti-clockwise to loosen the saw chain.
The saw chain is correctly tensioned, if on top it can lifted off
2–3 mm.
Tension the locking knob. Pull the chain in reverse with your
hand. The saw chain must glide easily on the chain bar but not
be too loose off the bar.
2
= 4.5 m/s , Uncertainty K =2,5 dB.
h
Tension saw chain
Corrective Action
Refill oil
Clean oil passage
Refill oil
Tension saw chain
Sharpen saw chain or replace
Tension saw chain
Sharpen saw chain or replace
Replace saw chain
Reduce force
Refill oil
Clean oil filler cap
Clean oil passage
Tension saw chain
Sharpen saw chain or replace
F 016 L70 917 | (29.6.12)
English | 11
Figure
1
2
3
4
5
6
7
8