Connecting Other Audio Components; Connecting The Subwoofer; Connecting Am/Fm Antennas - Pioneer Elite SC-91 Operating Instructions Manual

03

Connecting other audio components

This receiver has both digital and analog inputs, allowing you to connect audio components for playback.
When you set up the receiver you'll need to tell the receiver which input you connected the component to (see
also The Input Setup menu on page 48 ).
VIDEO/AUDIO
MONITOR OUT ASSIGNABLE 1 1 (SAT/CBL)
COAXIAL
ZONE 2 SAT/CBL DVR/BDR IN 1 (TV) 1
PRE OUT IN OUT IN (CD) OPTICAL
L DIGITAL IN ASSIGNABLE 1
R
VIDEO/AUDIO
1
MONITOR OUT ASSIGNABLE
ZONE 2 SAT/CBL SAT/CBL DVR/BDR IN 1
PRE OUT IN IN OUT IN ( CD )
L
R
! If your turntable has line-level outputs (i.e., it has a built-in phono pre-amp), connect it to the ANALOG IN 1
(CD) inputs instead.

Connecting the subwoofer

PRE OUT
SUBWOOFER
1
2
PRE OUT
SUBWOOFER
1
2
MONITOR OUT
! If you're not using a subwoofer, change the front speaker setting (see
! If you have two subwoofers, the second subwoofer can be connected to the SUBWOOFER 2 terminal.
Connecting two subwoofers increases the bass sound to achieve more powerful sound reproduction. In this
case, the same sound is output from the two subwoofers.
CD player, etc.
Select one
AUDIO OUT DIGITAL OUT
R ANALOG L OPTICAL COAXIAL
( SAT/CBL )
1
COAXIAL
( TV )
1
OPTICAL
DIGITAL IN
1
ASSIGNABLE
ANALOG
INPUT Powered
subwoofer 1
ANALOG
INPUT
Powered
subwoofer 2
Speaker Setting on page 91 ) to LARGE.

Connecting AM/FM antennas

Connect the AM loop antenna and the FM wire antenna as shown below. To improve reception and sound quality,
connect external antennas (see Connecting external antennas
a b
3
1 2
1 Pull off the protective shields of both AM antenna wires.
2 Push open the tabs, then insert one wire fully into each terminal, then release the tabs to
secure the AM antenna wires.
3 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
! If you plan to mount the AM antenna to a wall or other surface, secure the stand with screws (fig. c) before
clipping the loop to the stand. Make sure the reception is clear.
4 Place the AM antenna on a flat surface and in a direction giving the best reception.
5 Connect the FM wire antenna into the FM antenna socket.
For best results, extend the FM antenna fully and fix to a wall or door frame. Don't drape loosely or leave coiled up.
32
Connecting your equipment
on page 33 ).
c
5
ANTENNA
FM UNBAL 75
AM LOOP
4
ANTENNA
FM UNBAL 75
AM LOOP