Perspective View - Standard Horizon CP500 Owner's Manual

PLACE NAMES SIZE standard
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PLACE NAMES SIZE and press [ENT] or move
the ShuttlePoint knob to the right.
4. The menu now shows two selections, STANDARD, MEDIUM or LARGE.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.3

Perspective View

The Chart page may be show in a perspective (fly over) or normal mode during navigation.
Perspective view of the chart is a type of "bird's eye" view of a chart, and give you a more
realistic perspective of the chart. As the upper side of the map is more compressed than
the lower side, a wider map area is visible, so it allows showing more chart information
immediately ahead and around the cursor.
Perspective View ON
To activate this function follow the procedure:
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PERSPECTIVE VIEW and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the Chart page is shown.
CP500
PLACE NAMES SIZE medium
Figure 6.0.2 - Place Names Size
Figure 6.0.3 - Perspective View
PLACE NAMES SIZE large
Perspective View OFF
R
Page 47