Cable Connections - Axis 207 Installation Manual

Page 4
Mounting using the stand
1. If required, use the 3 supplied screws to fix the base plate to a
flat (horizontal or vertical) surface.
2. To use the shorter stand, unscrew the lock ring to release the
camera, and remove the extension section.
3. Attach the camera, adjust the angle and tighten the lock ring.
Shelf mounting
1. Attach the flexible clamp to the lock ring on the
camera.
2. Adjust the angle and tighten the lock ring.
3. Position the clamp and tighten the fixing screw
securely.

Cable Connections

1. Using the self-adhesive strip, attach the supplied cable clip to the rear panel and fasten the
power cable to it. This will prevent accidental cable disconnection.
2. Connect the AXIS 207 to the network using a standard RJ-45 network cable.
3. Connect the power adapter to the camera.
Important!
The AXIS 207 is designed for indoor use only, and must always be positioned where it is not exposed to
direct sunlight or strong halogen light, which can cause permanent damage to the camera's image sensor.
Damage as a result of exposure to strong light is not covered by the Axis warranty.
AXIS 207 Installation Guide