It’s not always easy to install new products on your network and this document describes some of the things you may need to configure to get your AXIS 207W connected to your Wireless network. Access Point/ Routers The AXIS 207W has been tested with a lot of different Access Points and Routers from different manufacturers.
Signal strength It’s important to have good signal strength. In the AXIS 207W web interface you can find info about the signal strength between the Axis 207W and the Access Point/Router: http://IP-address/admin/wlan.shtml?id=9 You can see the signal strength to Access Point/Router both if you’re connected to the camera Wirelessly or through a network cable.
Page 3
Changing the station mode in the AXIS 207W from Auto to Managed mode can prevent this. Go to Plain Configuration in the web interface and set the correct value and press the save button.
Technical Information Encryption It’s of course extremely important to set up the same configuration in the AXIS 207W as in the Access Point/Router. If they are not using the same encryption type and key there will be no communication. First select if you would like to use WEP or WPA/WPA2. If WEP is used it’s recommended to use open mode since shared key is not secure to use.
Page 5
AXIS 207W Network Camera Technical Information UPnP In some cases UPnP affects the Wireless connection and in these cases it’s recommended to switch this feature off. This is done from this page: http://IP-address/admin/UPnP.shtml Version 1.0 page 5 of 5...