Maintenance; Specifications - Panasonic SC-HC25 Owner's Manual

■ iPod or iPhone
You cannot switch on the iPod or iPhone.
• Examine that the battery of the iPod or iPhone is not depleted.
• Switch off the iPod or iPhone and the system before you connect the
iPod or iPhone. Connect the iPod or iPhone and try again.
No sound
• Switch off the iPod or iPhone and remove from the system. Connect
the iPod or iPhone to the system and switch it on and play it again.
■ Main unit displays
"NO PLAY"
• Examine the content. You can only play supported format.
"F76" or "F61"
• There is a power supply problem.
"ERROR"
• An incorrect operation was done. Read the instructions and try again.
"NOT MP3/ERROR"
• An unsupported MP3 format. The system will skip that track and play
the next one.
"VBR–"
• The system cannot show the remaining play time for variable bit rate
(VBR) tracks.
"NODEVICE"
• The iPod or iPhone is not connected. Examine the connection.
Memory reset (Initialization)
When the following situations occur, refer to the instructions below to
reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset the memory
1
Disconnect the AC power supply cord.
(Wait 3 minutes before you continue with step 2.)
2
While you press and hold [1, POWER] on the main unit,
connect the AC power supply cord again.
"– – – – – – – –" shows on the display panel.
3
Release [1, POWER].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this system.
• Before using chemically treated cloth, read the instructions that came
with the cloth carefully.
10
10

Specifications

■ Amplifier section
RMS output power stereo mode
Front Ch (both ch driven)
5 W per channel (6 ), 1 kHz, 10% THD
Total RMS stereo mode power
■ FM/AM tuner, terminals section
Preset station
Frequency modulation (FM)
Frequency range
Antenna terminals
Amplitude modulation (AM)
Frequency range
Headphone jack
Terminal
AUX (rear)
Terminal
■ Disc section
Disc played [8 cm (3") or 12 cm (5")]
CD, CD-R/RW (CD-DA, MP3 formatted disc)
MPEG-1 Layer 3, MPEG-2 Layer 3
Pick up
Wavelength
Laser power
Audio output (Disc)
Number of channels
FL = Front left channel
FR = Front right channel
■ Speaker section
Type
Speaker unit(s)
Full range
Impedance
Frequency range
■ General
Power supply
Power consumption
Dimensions (W x H x D)
Mass (weight)
Operating temperature range
Operating humidity range
Power consumption in standby mode
Note:
1) Specifications are subject to change without notice.
Mass and dimensions are approximate.
2) Total harmonic distortion is measured by the digital spectrum
analyzer.
FM 30 stations
AM 15 stations
87.9 MHz to 107.9 MHz (200 kHz step)
87.5 MHz to 108.0 MHz (100 kHz step)
75 (unbalanced)
520 kHz to 1710 kHz (10 kHz step)
522 kHz to 1629 kHz (9 kHz step)
Stereo, 3.5 mm ( /
1
Stereo, 3.5 mm ( /
1
790 nm (CD)
CLASS 1 (CD)
2 ch (FL, FR)
1 way, 1 speaker system (bass reflex)
8 cm (3 / ") cone type
1
8
60 Hz to 25 kHz (–16 dB)
90 Hz to 22 kHz (–10 dB)
AC 120, 60 Hz
400 mm x 221 mm x 110 mm
(15 / " x 8 / " x 4
3 3
4 4
[D = 69 mm (2 / ") minimum]
3
4
[D = 149 mm (5 / ") tray open]
3
4
2.1 kg (4.6 lb.)
0°C to +40°C
(+32°F to +104°F)
35% to 80% RH (no condensation)
0.1 W (approximate)
10 W
") jack
8
") jack
8
6
14 W
/ ")
1
2