Procedure 2.6 - Selecting United States Standard Or Metric Units (Units Built After April 1, 1996) - Precor C942 Service Manual

Procedure 2.6 - Selecting United States Standard or Metric
Units built after July 20, 1997 used the standard access codes. The keys on the display are
hypothetically numbered for 1 to 7 from left to right. Therefore, ENTER would be key 1,
INCLINE
would be key 2, etc. (see Diagram 2.1).
Selecting United States standard units causes information to be displayed in feet, miles and
pounds. Information is displayed in meters, kilometers and kilograms if metric units are selected.
After you have selected a measurement standard, the software compiles and records workout
information in the units of the measurement standard selected. Changing to the alternate
measurement standard after your workout has started will cause invalid data to be displayed. For
this reason, change the measurement standard only after turning ON the treadmill.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
With the Enter Your Weight banner scrolling, press keys RESET,5,6,7,1, sequentially.
b.
The message Press
Use the SPEED or INCLINE keys to select the measurement standard. The banner
c.
scrolling across the electronic console acknowledges the measurement standard
selected.
When the treadmill is turned off or unplugged it will remember the last measurement standard
selected.
Units (Units Built After April 1, 1996)
for MPH or for KPH will scroll across the screen.
C942 Treadmill
Page 11