Mounting And Wiring Your New Thermostat - White Rodgers NP110 Install Manual

4. MOUNTING AND WIRING YOUR NEW THERMOSTAT

4.1 Install new thermostat base
Mount your new thermostat base using the supplied screws. Drill holes and insert wall anchors to secure the
thermostat base to the wall, if necessary.
4.2 Connect wires to corresponding terminal blocks
Match each labeled wire to it's corresponding terminal on the mounted thermostat base. Insert each labeled wire into
the hole of it's matching terminal, and using the screwdriver, tighten the screw on the terminal block securely.
Take care when securing and routing wires so they do not short to adjacent terminals or rear of thermostat. Personal injury and/or property damage
may occur.
10
CAUTION
!