Polaris 480PRO Owner's Manual page 9

Action: Sweep hose sprays too much water
out of the pool.
Solution: 1. Adjust the speed of the sweep hose by
adjusting the easy-click settings.
2. Replace the sweep hose scrubber if it is
worn or missing.
3. Add a sweep hose weight (order part #B2)
to keep the sweep hose from spraying.
Action: The cleaner does not clean the
entire pool.
Solution: 1. Verify that feed hose reaches within 6" of
the farthest point of the pool.
If not, order a new hose section from your
Polaris dealer.
2. Check thrust jet for straight back position
that optimizes random turning.
3. While the cleaner is operating, hold it
upside down and look into the vacuum
tube. There should be four distinct, even
jets of water. If there are not, contact
Customer Service or a Polaris authorized
Service Center for assistance.
Action: The cleaner is running in circles on
its side.
Solution: 1. Check the filter bag, if full it can weigh the
cleaner down on one side.
2. Check the hose floats to make sure they
are spaced evenly.
Troubleshooting Worksheet
If these solutions do not result in improved
performance, contact the Polaris dealer who
sold you the cleaner or call Customer Service.
In order to provide faster and more convenient
service, please have the following information
available at the time of your call or when taking
the Polaris in for service.
1. Serial #:________________________
2. Wheel RPM:__________________
3. Is the back-up valve cycling?
Yes
4. Is the feed hose the proper
length?
Yes
5. Are the swivels rotating freely?
Yes
6. How often do you clean the filter
screen inside the in-line filter?
Never
Twice a Week
7. Are the vacuum jets obstructed?
(While the cleaner is operating, hold it upside down
and look into the vacuum tube. There should be four
distinct, even jets of water.)
Yes
8. Is the drive train functioning?
(As you spin each wheel independently, all the wheels
should spin.)
Yes
www.polarispool.com
No
No
No
Once a Week
Once a Month
No
No