Source Connections - Russound MCA-C3 User And Installation Manual

RNET Source Data Connections
The RNET Link In and Link Out can be used to connect the MCA-C3 to other
specified Russound RNET-enabled source equipment. The connection is made
using a CAT-5e patch cable from the Link Out of the controller and into the Link
In of the RNET-enabled source. Another CAT-5e patch cable can be used to link
out of that source and link into another RNET-enabled source in the system.
Use a standard CAT-5e patch cable with an RJ45 connector on each end.
Along with RNET data signals, the RNET Link In and Link Out port passes
source IR signals. To avoid potential cross-talk between the source-specific IR
repeating signal lines, the cable can not exceed 18 inches in length.
L
ST2 OOP
Smart Tuner
NEWMARKET, NH U.S.A. A NTENNA
FM C
OAX
RS-232 K P
LINK EYPAD ORTS
INTERFACE
I O
N UT
CAT-5e Cable
RNET Source Connection to MCA-C3
ST2 Tuner
L Serial#
T 2 OOP T 1
UNER UNER
A
NTENNA
FM C A O
A O OAX UDIO UTPUT
UDIO UTPUT
L R
L R
IR IR
12VDC 1.25A
MCA-C3 Controller
Russound MCA-C3 User and Installation Manual
Source Audio Connections
On the MCA-C3, sources 1 through 6 have standard stereo audio inputs. All
source inputs have audio signal sensing. These sources can be programmed
during zone setup to be global sources, or zones can be individually
programmed to restrict access to sources.
There is an internal AM/FM tuner that, if enabled, will occupy source 1. The
tuner is enabled with the SCS-C5 software and cannot be any other source
number. If utilizing the internal tuner, do not connect/configure another
source on source 1.
Connect each source output using quality RCA signal cables. Connect the Left
and Right Audio outputs from each source to the corresponding inputs on the
MCA-C3 controller.
RCA cable
Audio Source Connection to MCA-C3

SOURCE CONNECTIONS

CD Changer
MCA-C3 Controller
19