Transportation And Storage; Maintenance; Intended Use; Residual Risks - Ryobi rlt6030 Original Instructions Manual

Keep proper footing and balance at all times.
Do not walk backwards when using the product.
Walk, never run.
Keep bystanders, children and pets 15m away from the
area of operation, stop the product if anyone enters the
area.
Keep the cutting attachment below waist level.
Never operate the product with damaged guards or
without guards in place.
Never fit a metal replacement line.
Keep hands and feet away from the cutting means at
all times and especially when switching on the motor.
Beware, the cutting elements continue to rotate after
the motor is switched off.
Beware of objects thrown by the cutting means. Clear
debris like small stones, gravel and other foreign
objects from the work area before starting operation.
Wires or string may become entangled with the cutting
means.
Switch off and disconnect from the power supply before:
servicing
leaving the product unattended
cleaning your product or clearing a blockage
changing accessories
checking for any damage after hitting an object
checking for any damage if the product starts to
vibrate abnormally
performing maintenance
The small blade fitted to the lawn guard is designed to
trim the new extended line to the correct length for safe
and optimum performance. It is very sharp, do not touch
it particularly when cleaning the tool.
Always ensure that ventilation openings are kept clear
of debris.
Make sure the cutting head attachment is properly
installed and securely fastened.
Make sure all guards, deflectors and handles are
properly and securely attached.
Do not modify the machine in any way, this may
increase the risk of injury to yourself or others.
Use only the manufacturer's replacement cutting line.
Do not use any other cutting attachment.

TRANSPORTATION AND STORAGE

Stop the machine and allow it to cool before storing or
transporting.
Clean all foreign material from the product. Store it in a
cool dry and well-ventilated place that is inaccessible
to children. Keep away from corrosive agents such
as garden chemicals and de-icing salts. Do not store
outdoors.
For storage, always disconnect from power supply and
wind cable.
For transportation, secure the machine against
movement or falling to prevent injury to persons or
damage to the machine.
2 | English

MAINTENANCE

Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause possible injury, poor performance and may void
your warranty.
Servicing requires extreme care and knowledge
technician. For service we suggest you return the
product to your nearest authorized service center for
repair. When servicing, use only identical replacement
parts.
Switch off and disconnect from the mains before:
conducting any maintenance or cleaning work.
You may make adjustments and repairs described
here. For other repairs, contact the authorized service
agent.
For replacement line use only nylon filament line of
the diameter described in the specification table of this
manual
After extending new cutter line, always return the
product to its normal operating position before starting.
After each use, clean the product with a soft dry cloth.
Any part that is damaged should be properly repaired or
replaced by an authorized service centre.
Check all nuts, bolts and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition.

INTENDED USE

The product is only intended for use outdoors.
The product is designed for cutting grass, light weeds
and other similar vegetation at or about ground level.
The cutting plane should be approximately parallel to the
ground surface when trimming and approximately vertical
when edging.
The product should not be used to cut or trim hedges,
bushes or other vegetation where the cutting plane is not at
or about ground surface level.

RESIDUAL RISKS

Even when the product is used as prescribed, it is still
impossible to completely eliminate certain residual risk
factors. The following hazards may arise in use and the
operator should pay special attention to avoid the following:
Injury caused by vibration. Hold the tool by designated
handles and restrict working time and exposure.
Exposure to noise can cause hearing injury. Wear ear
protection and limit exposure.
WARNING
WARNING