Troubleshooting - Pro-Form performance 1450 User Manual

TROUBLESHOOTING
Most treadmill problems can be solved by follow=
ing the simple steps below. Find the symptom that
applies, and follow the steps listed, if further assis=
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a.
Make sure that the power cord is plugged into a
surge suppressor, and that the surge suppressor is
plugged into a properly grounded outlet (see page
18). Use only a surge suppressor that meets
all of the specifications described on page 18.
iMPORTANT: The treadmill is not compatible
with GFCl=equipped outlets and may not be
compatible with AFCl=equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
C.
Check the power switch located on the treadmill
frame near the power cord. if the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
Tripped
Reset
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above).
if the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. if the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a.
The console features a display demo mode,
designed to be used if the treadmill is displayed
in a store, if the screen shows a preset presenta-
tion when you remove the key, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds, if the demo
mode is still on, see step 7 on page 27 to turn off
the demo mode.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Calibrate the incline system (see step 4 on
page 29).
SYMPTOM: The iFit mode does not function
correctly
a. If the iFit mode is not functioning correctly, make
sure that the treadmill has the most current firm-
ware available (see step 3 on page 29).
SYMPTOM: The treadmill will not connect to the
wireless network
a. Make sure that the wireless settings on your con-
sole are correct (see step 4 on page 30).
b. Make sure that the settings for your wireless net-
work are correct.
c. if your wireless network is set to use WEP encryp-
tion, try setting it to WPA or WPA2 encryption
instead.
d. if you still have questions, see the front cover of
this manual.
33