Table of Contents
Advertisement
Note
Before you turn off the receiver, be sure to turn
down the volume level to avoid damaging your
speakers.
Tip
You can turn INPUT SELECTOR on the receiver or
press the input buttons on the remote control to
select the device you want.
You can adjust the volume differently using the
MASTER VOLUME knob on the receiver or the
+/– buttons on the remote control.
To turn the volume up or down quickly
Turn the knob quickly.
Press and hold one of the buttons.
To make fine adjustments
Turn the knob slowly.
Press one of the buttons and release it
immediately.
Setting HDMI signal format
Press HOME, then select [Setup] – [HDMI
Settings] – [HDMI Signal Format]. Select the
input you want.
[Standard format]: Selects this when you do
not use high bandwidth video format.
[Enhanced format]: Selects this when you
use high bandwidth video formats such as
4K/60p 4:4:4, 4:2:2 and 4K/60p 4:2:0
10 bit.
Note
For details on the high bandwidth video format,
visit the Help Guide.
When [Enhanced format] is selected, we
recommend you to use a Premium High Speed
HDMI Cable with Ethernet, which can support
bandwidth up to 18 Gbps.
Some devices (cable box or satellite box, Blu-ray
Disc player, and DVD player) does not work well
with [Enhanced format] setting. In this case, select
[Standard format].
If your TV have similar menu for high bandwidth
video format, check the setting on the TV menu
when you select [Enhanced format] on this
receiver. For details on the TV menu setting, refer
to the operating instructions of the TV.
Enjoying sound from speakers
located in other rooms (Zone 2/
Zone 3)
1
Connect the speakers located
in Zone 2/Zone 3 (page 20, 21).
2
Turn on the receiver.
3
(For Zone 2 only) Set the
priority for speaker terminals.
Press HOME, then select [Setup] –
[Speaker Settings] – [SURROUND BACK/
ZONE2 Priority] – [ZONE2 Terminals].
4
(For Zone 3 only) Set the
assignment for the
SURROUND/ ZONE 3 terminals
to [Zone3].
Press HOME, then
Select [Setup] – [Speaker Settings] –
[Speaker Pattern]* – [3.1], [3.0], [2.1] or
[2.0] – [Save]
Select [Surround Speaker Assign] –
[Zone3]
* Be sure to set the [Speaker Pattern] without
surround speakers.
5
Press HOME, then select [Zone
Controls].
Zone 2: Set [Zone2] – [Zone2
Power] – [On].
Zone 3: Set [Zone3] – [Zone3
Power] – [On]
You can also press ZONE SELECT on the
receiver repeatedly to select "ZONE 2" or
"ZONE 3", then press ZONE POWER on
the receiver.
6
Select [Zone2 Input] or [Zone3
Input], then select the source
signals you want to output.
You can also turn INPUT SELECTOR on the
receiver while "2. xxxx"* or "3. xxxx"*
appears on the display panel.
* "xxxx" is the input name.
37
GB
Hide quick links:
Advertisement
Table of Contents
