Bosch NIT3065UC Use And Care Manual page 27

Visual indication
None
EÖ + number/
p + number/
 + number/
F0/F9
F2
F4
{b
{c/{d
Do not place any pans on the control panel.
Note:
Fault
There has been a power
outage.
The appliance has not
been connected in
accordance with the
connection drawing.
Electronic system
malfunction.
Electronic system
malfunction.
An internal error has
occurred.
The cooking element is too
hot and has turned off.
The pan is too close to the
control panel.
Incorrect input voltage, not
within normal working
limits.
The cooking element has
overheated and has
switched off to protect the
cooktop.
A gap may form between the countertop and the cooktop. For this reason, there is a
flexible seal all around the cooktop. Due to the characteristics of the material, there
can be irregularities in the glass ceramic surface. Because of the mirror-smooth
surface of the cooktop, it is possible for even the smallest of bubbles, less than 1
mm in diameter, to be visible. They are not detrimental either to the functionality or
the durability of the glass ceramic cooking surface.
Measure
Check other electrical appliances to see if there has been
a power outage.
Check that the appliance has been connected in
accordance with the connection drawing.
If the above checks do not solve the problem contact the
Technical Assistance Service.
Disconnect the cooktop from the power supply. Wait a few
seconds and then reconnect it.
If the indicator persists contact the Technical Assistance
Service.
Disconnect the cooktop from the power supply. Wait a few
seconds and then reconnect it.
If the indicator persists contact the Technical Assistance
Service.
Remove the pans from the cooking elements. F2
disappears when you press the control panel once the
cooktop has cooled down. Wait a few minutes until the
cooking elements have cooled down slightly. If F2 appears
again after the element is turned back on, the cooktop is
still too hot. Turn off the elements and allow them to cool
further.
Verify that the pot or pan is properly positioned on the
element.
Check that there is nothing hot on the control panel.
Contact the electricity distributor.
Wait for the electronic system to cool down and then
switch it on again.
27