Table of Contents
Advertisement
Option 91 - Comm Channel 2 Reports
Default = Off; Range = 0, 1, Off
This option determines which reports are ultimately sent to the
network central station receiver 2 by the Ethernet Interface
module. Set this option to 0 to have Simon send all reports to
Comm Channel 2 (network receiver 2) of the module. Set it to
1 to send only alarms and manual communication tests to the
module.
Option 92 - Comm Channel 3 Reports
Default = Off; Range = 0/Off
This options determines which reports are ultimately sent to
the premisesconnect.com website by the Ethernet Interface
module. Set this option to On to have Simon send all reports to
Comm Channel 3 (premisesconnect.com).
Other Simon Options
If your Simon-Ethernet Interface module system connects to
the premisesconnect.com website, the following options may
also be set to On depending on the configuration of the
system:
•
Option 20 - Phone Test
•
Option 21 - Opening Reports
•
Option 22 - Closing Reports
•
Option 23 - Forced Arm Report
•
Option 24 - AC Fail
•
Option 25 - CPU Low Battery
•
Option 45 - Sensor Alarm Restoral
Refer to the Simon Installation Instructions for more
information.
Registration Options
Note: "ACMD" is spoken when the panel lists Remote Options
2, 6 and 16.
Registration is necessary if the system will be communicating
with the premisesconnect.com web site. Registration is not
necessary if the system will only be communicating with a
TCP/IP central station receiver. The following options (Remote
Options 1-4), as well as Simon Option 07 (Account Number)
are used to register the system.
Remote Option 1- Module Registration Status
Default = Off; Range = On/Off
When the Ethernet Interface module is successfully registered
this option is switched On automatically. This option must be
Off before attempting to register or re-register the Ethernet
Interface module.
Ethernet Interface Installation Instructions
Remote Option 2- Register Module Command
Default = N/A; Range = N/A
Used to register the Ethernet Interface module.
1.
Press Add
2.
Press Option #
3.
Press Test
4.
Press Option # until panel says "Remote Option 2..."
5.
Press Done to register the module.
Remote Option 3- Dealer ID
Default = 000; Range = 1-10-digit numeric
The Dealer ID is unique to each installer and is assigned by
UTC Fire & Security. The Dealer ID must match an existing
Dealer ID stored on the premesisconnect.com system.
Remote Option 4- Line Number
Default = 0001; Range = 1-10-digit numeric
The Line Number is a 1 to 10-digit numeric identifier linked to
the primary reporting channel number of the panel. It is used
as a prefix to the panel Account Number.
Module Options
The following options are used to customize the operation of
the Ethernet Interface module.
Remote Option 5- DHCP On/Off
Default = On; Range = On/Off
DHCP is used to assign an IP address to the Ethernet
Interface module automatically on a network containing a
DHCP Server (your router typically will have a built-in DHCP
Server). Typically DHCP should be left On. Remote Options 7,
8 and 9 must be programmed if DHCP is off.
Note: When this option is changed, it may be necessary to
reset the module (Remote Option 6) in order for the change to
take effect.
Remote Option 6- Reset Module Command
Default = N/A; Range = N/A
Used to reset the Ethernet Interface module.
1.
Press Add
2.
Press Option #
3.
Press Test
4.
Press Option # until panel says "Remote Option 6..."
7
Advertisement
Table of Contents
