Table of Contents
Advertisement
4.
Press Option repeatedly until you hear "Option 7" or press
0, then 7.
5.
Enter the Account Number using the numbered keys.
Press 9 then the Minutes + button to enter letters (A-F).
Pressing the Minutes + button repeatedly scrolls through
the alphanumeric list (A-F, 0-9).
6.
Press Done when the Account Number is entered.
Note: The Contact ID reporting method does not allow the use
of the letter A in account numbers.
See the Simon Installation Instructions for complete panel
programming instructions.
Dealer ID
The Dealer ID (Remote Option 3) is a numeric identifier
assigned by UTC Fire & Security that can be up to 10 digits
long. It is unique for each dealer or installer. The Dealer ID
must match an existing Dealer ID stored on the server.
The Dealer ID may be pre-programmed. Verify there is no
Dealer ID programmed before setting the Dealer ID.
To verify the Dealer ID:
1.
Enter Utility Access Code 1 (Dealer Code) if you are not
already in program mode.
2.
Press Option #.
3.
Press Test. This switches to the Remote or Ethernet
Interface options menu and the panel begins announcing
the values of all the remote options.
4.
Listen until you hear the value of Remote Option 3. (Press
Cancel to stop the panel from listing remote option
values.)
To set the Dealer ID:
1.
Enter Utility Access Code 1 (Dealer Code) if you are not
already in program mode.
2.
Press Add.
3.
Press Option #.
4.
Press Test. This switches to the Remote or Ethernet
Interface options menu.
5.
Press Option # repeatedly until you hear "Remote Option
3..."
6.
Enter the Dealer ID using the numbered keys.
7.
Press Done. The panel will repeat the Dealer ID.
4
Line Number
The Line Number (Remote Option 4) is a numeric identifier that
can be up to 10 digits long.
The Line Number may be pre-programmed. Verify there is no
Line Number programmed before setting the Line Number.
To verify the Line Number:
1.
Enter Utility Access Code 1 (Dealer Code) if you are not
already in program mode.
2.
Press Option #.
3.
Press Test. This switches to the Remote or Ethernet
Interface options menu and the panel begins announcing
the values of all the remote options.
4.
Listen until you hear the value of Remote Option 4. (Press
Cancel to stop the panel from listing remote option
values.)
To set the Line Number:
1.
Enter Utility Access Code 1 (Dealer Code) if you are not
already in program mode.
2.
Press Add.
3.
Press Option #.
4.
Press Test. This switches to the Remote or Ethernet
Interface options menu.
5.
Press Option # repeatedly until you hear "Remote Option
4..."
6.
Enter the Line Number using the numbered keys.
7.
Press Done. The panel will repeat the Line Number.
Creating a Premisesconnect.com Account
You can create an account for the system before or after
installing and registering the system at the premises. Typically
it will be done before installation, so any problems can be
resolved before installation. Follow the procedures on the
premisesconnect.com website to create an account.
Note: Account ID must be the same as the Account number
(Simon Option 07) programmed into the Simon panel.
The following is some of the information that will have to be
added when creating an account:
•
Account name, address and phone
•
Account ID
•
Primary Contact
Ethernet Interface Installation Instructions
Advertisement
Table of Contents
