Declaration Of Conformity - Bosch GAS 55 M AFC Professional Original Instructions Manual

20 | English
19 Castor frame
20 Locking latch of filter cover
21 Holder for crevice nozzle/elbow
22 Holder for vacuum tubes
23 Drain hose
24 Holder for floor nozzle
25 Tool sleeve
26 Air diffuser
27 Vacuum hose
28 Elbow
29 Disposal bag
30 Flat-fold filter(PES)
31 Crevice nozzle
32 Rubber lip
33 Brush insert
34 Floor nozzle
35 Vacuum tube
36 Retainer for vacuum-hose holder
37 Snap-fastener
38 Signalling LED
39 Filter cover
40 Level sensors
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.
Technical Data
Wet/dry vacuum cleaner
Article number
Rated power input
Frequency
Container volume (gross)
Net volume (for fluids)
Dust bag contents
Max. vacuum*
– Vacuum cleaner
– Turbine
Max. flow rate*
– Vacuum cleaner
– Turbine
Max. vacuum capacity
Surface of flat-fold filter
Dust category
Weight according to
EPTA-Procedure 01/2003
Protection class
Degree of protection
Ø
* Measured with a 35 mm and 5 m long vacuum hose
The values given are valid for nominal voltages [U] of 230 V. For lower
voltage and models for specific countries, these values can vary.
1 619 929 L62 | (15.2.13)
GAS 55 M AFC
3 601 JC3 3..
W 1200
Hz 50/60
l 55
l 40
l 27
230
hPa
hPa 254
36
l/s
l/s 74
W 1380
2
m 0.615
M
kg 16.2
/I
IP X4
Automatic Start/Stop feature*
Rated voltage
EU 220 –240 V
UK 110 V
UK/DK 240/230 V
CH 230 V
* Specification of the allowable load of the connected power tool (coun-
try-specific)
Noise Information
Measured sound values determined according to EN 60704.
Typically the A-weighted sound pressure level of the vacuum
cleaner is lower than 70 dB(A). Uncertainty K= 3 dB.
The noise level when working can exceed 80 dB(A).
Wear hearing protection!

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical data" is in conformity with the fol-
lowing standards or standardization documents: EN 60335
and the directives 2011/65/EU, 2006/42/EC,
2004/108/EC including their amendments.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
15.02.2013
Assembly
 Before any work on the vacuum cleaner itself, pull the
mains plug.
Mounting the Vacuum-hose Holder (see figure A)
– Slide the vacuum-hose holders 4 firmly from above into the
retainers 36 intended for this purpose, until they engage.
Mounting the Vacuum Hose (see figure B)
– Mount the vacuum hose 27 onto the hose connection
piece 3 and turn it in clockwise direction to the stop.
Note: While vacuuming, an electrostatic charge develops in
the vacuum hose and accessories caused through the friction
of the dust, which the operator could experience in the form
of static discharging (dependent on environmental influences
and physical perception).
As a general rule, Bosch recommends using an anti-static vac-
uum hose (accessory), when vacuuming fine dusts and dry
materials.
max. power min. power
output output
2200 W 100 W
750 W 100 W
1800 W 100 W
1100 W 100 W
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Bosch Power Tools