D-Link dap-3690 Quick Installation Manual page 8

Airpremier n concurrent dual band outdoor poe access point

Hide thumbs Also See for dap-3690:

Table of Contents

Available languages

Configuration

Connect the DAP-3690 to a Local Computer

If you are configuring the DAP-3690 locally (without connecting its power injector to a wired

LAN), connect a PC to the power injector's Ethernet port using a Category 5 Ethernet cable.

1. Assign a static IP address to your PC which is in the same network segment with the

DAP-3690. As the default IP address of this unit is 192.168.0.50, you may choose from

192.168.0.1 to 192.168.0.254, except 192.168.0.50.

2. Test the link status between your PC and the DAP-3690. Start a command prompt and

execute a continuous ping command "ping 192.168.0.50 –t". If ping to the wireless bridge

is successful (as shown below), open Internet browser and enter the bridge's IP address

in the address filed and press Enter.

Note: Considering convenient configuration, it is recommended to configure local and remote DAP-3690

respectively on two computers. TTL time may vary depending on the operating system.

D-Link DAP-3690 Quick Install Guide

Table of Contents