Wallplate Installation - Honeywell PRO TH3210D Manual

PRO TH3210D Non-programmable Digital Thermostat
Grasp top and bottom of wallplate
and pull to remove from thermostat.
Remove the wallplate from the ther-
mostat as shown at left, then fk_llow
directions below _k>r mounting.
1 Pull wires through wire hole.
2 Position wallplate on wall, level and
mark hole positions with pencil.
3 Drill holes at marked positions as
shown below, then tap in
supplied wall anchors.
4 Place wallplate over anchors, insert
and tighten mounting screws.
Drill 3/16" holes for drywall.
Drill 7/32" holes for plaster,