Wallplate Installation - Honeywell PRO 1000 Series Installation Manual

Installation Guide

Wallplate installation

CAUTION: ELECTRICAL HAZARD
Can cause electrical shock or equipment damage. Disconnect power
before beginning installation.
1 Loosen the locking screw at the bottom of the thermostat. Note that the screw is
captive and cannot be removed from the wallplate.
2 Separate the thermostat from the wallplate as per Figure 1.
3 Position the wallplate against the wall and mark hole positions with a pencil.
NOTE: Levelling is for esthetics only and will not affect the performance of the
thermostat.
4 Drill holes at the marked positions and insert supplied wall anchors.
5 Pass the wires through the large opening located at the bottom center of the wallplate
as per Figure 2.
6 Secure the wallplate to the wall with supplied mounting screws as per Figure 3.
7 Connect the wires to the terminals.
Figure 1
MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube,
do not place the old control in the trash. Contact your local waste
management authority for instructions regarding recycling and proper
disposal.
Figure 2
2
Figure 3