Toro Z Master Commercial 2000 74141TE Operator's Manual page 47

6. Insert the height adjustment pin into the 3 inch (7.6
cm) cutting height location.
7. Release the transport lock and allow the deck to lower
to the cutting height.
8. Raise the discharge chute.
9. On both sides of the deck, measure from the level
surface to the front tip of the blade (Postion A).
The measurement should read 3 inches (7.6 mm)
(Figure 70).
Figure 70
1. 3 inches (7.6 cm) at A is
correct
2. 3 1/4 inches (8.3 cm) at B
is correct
10. If needed, loosen the whizlock nut on the side of the
yoke and the jam nut on top. Fine tune the screw
adjuster by turning it to get 3 inch (7.6 mm) height (see
Figure 71).
To increase the height, turn the adjuster screw
clockwise; to decrease, turn counterclockwise.
3. Measure here from the
blade tip to hard surface
4. Measure at A and B on
both sides
1. Whizlock nut
2. Adjuster screw
11. If the front deck links do not have enough adjustment
to achieve accurate cut height , the single point
adjustment can be utilized to gain more adjustment.
12. To adjust the single point system, loosen the two bolts
at the bottom of the height of cut plate. Refer to
Figure 72.
1. Bolts at the bottom of the height-of-cut plate
13. If the deck is too low, tighten the single point
adjustment bolt by rotating it clockwise. If the deck is
too high, loosen the single point adjustment bolt by
rotating it counterclockwise (Figure 73).
47
Figure 71
3. Jam nut
4. Yoke
Figure 72
g017441
1
g017442