Table of Contents
Advertisement
700 Series Managed Switch User's Guide for Software v2.1
IP-filter address
The
allows you to enter and remove IP address from the approved list. Use
IP-filter address
the No command to remove an IP address.
Syntax
FSM726(config)# system ip-filter address <IP-address>
Where
= an IP address that is authorized to access the management.
<IP address>
IP-Mode
The I
command sets the IP assignment mode of the switch. There are three modes
P-Mode
available to the user.
Manual – The user manually enter IP related information
BootP – Bootstrap Protocol, which allows the FSM726 switch to discover its own IP address from
a BootP server on the network
DHCP – The switch accepts DHCP broadcast from a DHCP server and automatically configure IP
related information
Syntax
FSM726(config)# system ip-mode [manual | bootp | DHCP]
Mask
Use the Mask command to set the network mask.
Syntax
FSM726(config)# system mask <network mask>
Where
= network mask of your network
<network mask>
Gateway
Use the
command to set the default gateway
Gateway
Command Line Interface
6-27
SM-10004-02
Advertisement
Table of Contents
