Jumper Settings; Clear Cmos Data - LanParty X48-T3RS User Manual

E
English
Chapter 2 - Hardware Installation

Jumper Settings

Clear CMOS Data

Clearing CMOS Data using JP2
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
c) The overclocked settings in the BIOS resulted to the system's in-
stability or caused system boot up problems.
you can reconfigure the system with the default values stored in the
ROM BIOS.
To load the default values stored in the ROM BIOS, please follow
the steps below.
1. Power-off the system then unplug the power cord.
2. Set JP2 pins 2 and 3 to On. Wait for a few seconds and set
JP2 back to its default setting, pins 1 and 2 On.
3. Now plug the power cord then power-on the system.
10
1 2 3
JP2
1-2 On: Normal
(default) Clear CMOS Data
1 2 3
2-3 On: