Usals Setting - Topfield TF5010PVR User Manual

MENU OPERATIONS
D. LNB Setting
Please refer to LNB setting of this chapter.
E. Motorized DiSEqC1.2
Select Enable or Disable. If you are using DiSEqC1.2 antenna, set to Enable.
F. DiSEqC Command Mode
Change the current mode between User and Installer modes.
-User: This mode is used to fine-tune the position of the motor for better reception.
-Installer: This mode is used to search for the position of a satellite manually.
G. Movement: In case of User mode, the movement is adjustable by fine-tuning.
In case of Installer mode, the movement is adjustable by East , West going command.
H . Motor Control
- Goto : Move the motor to the stored position of the selected satellite.
- Store : Store the current position of the motor for the selected satellite.
* The followings are available only at the Installer mode.
- Recalculate : Recalculate the position of the Stab Rotor motor.
- Goto Ref : Go to reference.
- Limit E , Limit W : Set the limits of East and West position.
- Limit Off : Remove the limitation.
- Reset : Reset all the stored position of the motor relative to the "0" position
I . Channel Search
After saving the DiSEqC configuration at the highest signal quality, press OK button to
start channel searching of the selected satellite.

USALS Setting

USALS is very convenient motorized DiSEqC system that supports DiSEqC 1.3
command and also can get the satellite position automatically if you know your
geographical location. Basically, the listed satellites have its Longitude and therefore the
angle of the satellite can be calculated without problem.
If you have USALS motorized system, then you can use the USALS as followings.
35