Electrical Connection - Smeg SIHP3+WG4 Directions For Use Manual

How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
His installation has to be done carelessly, in conformity of the following drawing.

ELECTRICAL CONNECTION

The installation of this appliance and the connection to the electrical network should be
entrusted only to an electrician perfectly to the fact of the normative regulations and which
respects them scrupulously.
Protection against the parts under tension must be ensured after the builting-in.
The data of connection necessary are on the stickers place on the hob casing near the
connection box.
The connection to the main must be made using an earthed plug or via an omnipolar circuit
breaking device with a contact opening of at least 3 mm.
The electrical circuit must be separated from the network by adapted devices, for example :
circuit breakers, fuses or contactors.
Mains
400V~2P+N 50Hz 2 Phases + N
230V~ 2P 50Hz 2 Phases
230V~1P+N 50Hz 1 Phases + N
( * ) calculated with the simultaneous factor following standard TN 60 335-2-6/1990
Connection Cable size
4 x 1.5 mm2 H 05 RR 16 A *
3 x 2,5 mm2 H 05 RR 25 A *
3 x 2,5 mm2 H 05 RR 25 A *
Stick the gasket (2) two milimeters from
the external edge of the glass, after
removing the protection sheet (3).
Cable Protection calibre
14