Zone Options; Partition Label - DSC Maxsys PC4010 Programming Manual

Zone Options

Enabling or disabling options by zone.
ZONE OPTIONS
(2)
Bell Audible?
BELL AUDIBLE
YES = An alarm causes the bell output to activate.
Y
NO = Silent alarm.
Bell Pulsed?
BELL PULSED
YES = The bell output will pulse when the zone is in alarm.
N
NO = The bell output will be steady when the zone is in alarm.
Zone Bypass Enabled?
BYPASS ENABLED
YES = The zone may be manually bypassed.
Y
NO = The zone cannot be bypassed.
Door Chime Function?
CHIME FUNCTION
YES = Every keypad on the partition will chime both when the zone is violated and when the
Y
NO = The zone will not chime the keypads.
Zone Can Force Arm?
FORCE ARM
YES = The partition may be armed with the zone violated. The zone will be temporarily
N
NO = The partition cannot be armed if this zone is open.
Swinger Shut Down?
SWGR SHUT DOWN
YES = After a zone causes a programmed number of alarms, the zone will shut down so that no
Y
NO = Swinger Shut Down disabled.
Transmission Delay?
TX DELAY ?
YES = The reporting of zone alarm will be delayed for the programmed time. If the system is
N
NO = When an alarm occurs, the reporting code is transmitted immediately.

Partition Label

Programming a partition name label. This label is programmed in the same manner as LCD
PAR NAME LABEL
messages or custom zone ID (see "Event Messages").
(4)
Note: The maximum length of the partition name label is 14 characters.
PARTITION AREA
zone is then secured. The partition must be disarmed for the chime option to function.
bypassed, and when the zone is secured it will be added back into the system.
further transmissions are sent to the monitoring station. The bell can follow Swinger Shut
Down if programmed. (See "Shut Down 24 Hrs ", "Swinger Limit" and "Bell Shut Down.)
disarmed within this time, no alarm signal will be communicated. (See "Zone TX
Delay".)
ADD / EDIT PAR ZONE ASSIGNMENT
55
ADD / EDIT ZONES