NETGEAR WG511U Double 108 Mbps Wireless PC Card WG511U WG511U User Manual page 29

User's Manual for the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U
Verify wireless connectivity to your network.
Verify that your Connection and Status Monitor information matches your wireless
a.
network.
Check the two LEDs on the WG511U:
b.
Table 3-2:
LED 1
(below the
word
NETGEAR
on the left)
Slow blink
Alternate
blink
Slow blink
Fast blink
Verify connectivity to the Internet or network resources.
c.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation section of
the Reference Manual on the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus
WG511U Resource CD.
Basic Setup
LED Descriptions
LED 2
(below the
word Meaning
NETGEAR
on the right)
OFF Power save mode (default from power up or reset)
Alternate Looking for network association
blink Power LED goes ON; Network LED is OFF; then Power
LED goes OFF and Network LED goes ON
Slow blink Associated or joined with network; no activity
Fast blink Associated or joined with network; blink rate increases
with activity on the network over the air or locally on the
network
August 2004
3-11