Denon DCD-50 Owner's Manual page 34

Contents Connections
Troubleshooting
If a problem should arise, first check the following.
1. Are the connections correct?
2. Is the set being operated as described in the owner's manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table below.
Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase.
o Power does not turn on / Power is turned off
Symptom
Power is not turned on.
0
Power automatically turns
0
off.
o LED is flashing
Symptom
Flashing red.
0
Front panel Display
Playback
Check whether the power plug is correctly inserted into the power outlet.
The Auto Standby mode is set. The Auto Standby mode switches the unit to standby mode when the unit
is not operated for approximately 30 minutes. To disable the Auto Standby mode, press and hold the
power operation button (X) for more than 5 seconds when the Auto Standby mode is enabled.
A circuit in the unit has malfunctioned. Disconnect the power and contact the repair center.
Rear panel
Settings
Cause / Solution
Cause / Solution
34
Remote
Tips Appendix
Page
Page
Index
21
30
－