NETGEAR WG111V2 User Manual page 28

NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111v2 User Manual
3. Save your settings in a Profile.
a. Click Save Profile.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
You can use the ping utility to verify your wireless connection
a. On the Windows taskbar click Start, and then click Run.
b. Assuming the target PC is configured with 192.168.0.1 as its IP address, type
192.168.0.1
Figure 16
c. This sends a continuous ping to the device with the 192.168.0.1 static IP address. The ping
response should change to "reply."
Figure 17
18
and then click OK.
v3.0, January 2007
ping -t