List Of Error Codes - Brother bas-311hn Instruction Manual

8. LIST OF ERROR CODES

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the control box cover. Touching areas where high voltages are present can result in severe injury.
If a malfunction occurs with the sewing machine, a buzzer will sound and an error code will appear on the screen.
Follow the remedy procedure to eliminate the cause of the problem.
Switch-related errors
Code
The STOP switch was pressed.
E010
Press the RESET key to clear the error.
The STOP switch was pressed.
Press the RESET key to clear the error.
E011
You can touch the
The STOP switch was pressed.
E012 Press the RESET key to clear the error, and then depress the start switch to move the feed mechanism to the
home position.
The stop switch was still being pressed when the power was turned on, or there is a problem with the stop switch
E015 connection.
Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.
Problem with the stop switch connection.
E016
Turn off the power, and then check that connector P9 on the main P.C. board is properly connected.
The start switch was pressed without the work clamp being lowered.
E020
First lower the work clamp.
Start switch was being depressed when power was turned on.
(For a foot switch, the foot switch was being depressed to the 2nd step.)
E025 Release the switch.
(For a foot switch, if E025 is not cleared even when the switch is released, readjust the depression stroke. Refer
to P.49 - P.50.)
Work clamp switch was being depressed when power was turned on.
(For a foot switch, the foot switch was being depressed to the 1st step.)
E035 Release the switch.
(For a foot switch, if E035 is not cleared even when the switch is released, readjust the depression stroke. Refer
to P.49 - P.50.)
Machine head tilting was detected after the power was turned on.
E050 Turn off the power, and then return the machine head to its original position.
Check that connector P14 on the main P.C. board is properly connected.
Machine head tilting was detected while the sewing machine was operating.
E051
Turn off the power, and then check that connector P14 on the main P.C. board is properly connected.
Machine head tilting was detected when the power was turned on.
E055 Turn off the power, and then return the machine head to its original position.
Check that connector P14 on the main P.C. board is properly connected.
Touch panel was being touched when power was turned on.
E064
Release the touch panel.
A key on the LCD panel was still being pressed when the power was turned on, or key is faulty.
E065
Release the key.
DANGER
Cause of error and remedy
keys on the LCD panel to move the feed in order to continue sewing.
BAS-311HN, BAS-326H
8. LIST OF ERROR CODES
53