Threading The Upper Thread - Brother bas-311hn Instruction Manual

4-2. Threading the upper thread

Thread the upper thread correctly as shown in the illustration below.
* When using threading mode for threading, the thread can be threaded more easily.
Refer to <Threading mode> (P. 24)
[If using cotton thread or spun thread]
3559B
3059B
• Turn the machine pulley (2) and raise the thread take-up (3) to its highest position before threading the upper thread.
(This will make threading easier and it will prevent the thread from coming out at the sewing start.)
• When threading the thread through the needle, allow a distance of approximately 42 mm between the needle hole and the end
of the thread.
If it is too long, the thread may become tangled, and if it is too short, the thread may pull out at the sewing start.
• If you would like to adjust the sensitivity of the thread breakage sensor, refer to "7-2. Adjusting the sensitivity of the thread
breakage sensor".
[If using synthetic thread]
BAS-311HN, BAS-326H
4. PREPARATION BEFORE SEWING
Use the optional needle cooler unit.
Thread the
upper thread
Needle cooler
3558B
23