Manual Configuration - NETGEAR DG814 DSL Reference Manual

Reference Manual for the Model DG814 DSL Modem Internet Gateway
A DNS server is a host on the Internet that translates Internet names (such as www
addresses) to numeric IP addresses. Typically your ISP transfers the IP addresses of one or
two DNS servers to your gateway during login. If the ISP does not transfer an address, you
must obtain it from the ISP and enter it manually here. If you enter an address here, you
should reboot your PCs after configuring the gateway.
Click on Apply, then proceed to
4.

Manual Configuration

You can manually configure the gateway in the Basic Settings menu shown in
these steps:
Select whether your Internet connection requires a login.
1.
Select 'Yes' if you normally must launch a login program such as Enternet or WinPOET in
order to access the Internet.
• If your service provider does not require a login program enter your Account Name (may
also be called Host Name) and Domain Name. These parameters may be necessary to
access your ISP's services such as mail or news servers.
Proceed to Step 2
• If your service provider uses PPP over Ethernet (PPPoE), select Encapsulation as PPP
over Ethernet, and enter these additional parameters:
Enter the PPPoE login user name and password provided by your ISP. These fields are
a.
case sensitive.
If your connection supports multiple ISPs, enter the Service Name of the one you use.
b.
Otherwise leave Service Name blank.
If you wish to change the idle timeout, enter a new value in minutes.
c.
Proceed to Step 2
Note: You will no longer need to launch the ISP's login program on your PC in order to access
the Internet. When you start an Internet application, your gateway will automatically log you
in.
• If your service provider uses PPP over ATM (PPPoA), select Encapsulation as PPP over
ATM, and enter these additional parameters:
Enter the PPPoA login user name and password provided by your ISP. These fields are
a.
case sensitive.
4-8
"Completing the Configuration" on page 4-9.
Figure 4-2
Basic Configuration of the Gateway
using