Expanded System Disk Memory - Xerox 4635 Installation Planning Manual

Expanded system disk memory

Enhanced graphics ink and font memory (EGIFM)
Floppy disk drive
Printer options
Feeder stacker
Bypass transport
XEROX 4635 LASER PRINTING SYSTEM INSTALLATION PLANNING GUIDE
XPSM Xerox Print Service Manager (XPSM) is a printing solution for
production printing environments. It consists of both client and
server sites.
The 4635 LPS has one standard 650 MB system disk with optional
expansion up to 2,600 MB in 650 MB increments.
The 4635 LPS has a standard 64 Mbits of font/graphic memory
that can be expanded to 256 Mbits.
When installed, the optional floppy disk drive is located in the
system controller, to the right of the 1/4 inch cartridge tape
drive. It allows you to transfer files between a floppy disk and
the system controller's hard disk. Therefore, it provides an
alternative way for backing up and restoring system controller
rigid disk files.
The 4635 LPS has an Inverter Feeder Stacker, and up to three
optional feeder stackers.
Refer to the section "Printer components" in the "LPS overview"
chapter for information on the feeder stackers.
The ability to add finishers to your 4635 LPS is made possible by
the Bypass Transport option. Finishers increase your production
capabilities by providing a wide range of finishing choices, such
as stitching, shrink wrapping, and so on.
Connected to the feeder/stacker, the bypass transport allows
finishers to interface directly with your 4635 LPS. The bypass
transport meets the Xerox Document Feeding and Finishing
Architecture (DFA) Level 1 specifications.
Figure 2-2 shows the 4635 LPS with the optional bypass transport
and the paper output and input locations.
LPS OPTIONS
2-3