Connection Status - Sagem F@st 1201 Quick Installation Manual

SAGEM F@st™ 1201
The result of the tests carried out by your modem/router’s «DSL router» configuration
tool is displayed in the «Diagnostics» window. These tests relate to the connections to
the LAN, your DSL Service Provider and your Internet Service Provider (ISP).
A hypertext link (help) enables the user to access contextual help. This help
provides explanations about the status of the connection (PASS green,
DOWN orange and FAIL red) and provides the appropriate repair procedures.

Connection status

Colour
Status
Indicates that the test was carried out correctly
Green
PASS
Indicates that an interface (ETH, USB) was not detected.
Orange
DOWN
Indicates that a test failed or that a command cannot be
FAIL
Red
launched.
If a test displays a «FAIL» status, click on «Help» then the
«Rerun Diagnostic Tests» button at the bottom of the «Help» page to make
sure that the test was suitable. If the test still displays «FAIL», you must
follow the repair procedure displayed on this page.
If you are having trouble connecting to the Internet we recommend that you restart your
modem/router or possibly return to the factory configuration using the procedures
described below.
Restarting your modem/router
To restart your modem/router, click on the «Reboot» button in the top right of your HTTP
configuration tool’s welcome page.
Returning to the factory configuration
To return to the factory configuration:
in the top left of your HTTP configuration tool’s welcome page select the
l
Management heading then the Restore default sub-menu in the Settings menu.
or press and hold for about 10 seconds on the button marked «REG» on the back of
l
your modem/router.
Troubleshooting
Meaning
IMPORTANT
12