Emergency Starting Engine - Yamaha 40v Owner's Manual

Trouble Recovery
wheel or other moving parts when the
engine is running. Do not install the
starter mechanism or top cowling after
the engine is running.
Do not touch the ignition coil, spark
G
plug wire, spark plug cap, or other elec-
trical components when starting or op-
erating the motor. You could get an
electrical shock.
EMU29562

Emergency starting engine

1. Remove the top cowling.
2. Remove the start-in-gear protection ca-
ble from the starter, if equipped.
1. Start-in-gear protection cable
3. Remove the starter/flywheel cover after
removing the bolt(s).
4. Prepare the engine for starting. For fur-
ther information, see page 39. Be sure
the engine is in neutral and that the clip
76
is attached to the engine shut-off switch.
The main switch must be "
equipped.
1
ZMU03425
5. If equipped the choke knob, pull out it
when the engine is cold. After the engine
starts, gradually return the choke knob
to its home position as the engine warms
up.
ZMU03139
6. Insert the knotted end of the emergency
starter rope into the notch in the flywheel
" (on), if
ZMU03140
ZMU03355