Yamaha 40v Owner's Manual page 47

6. After the engine starts, slowly return the
manual starter handle to its original po-
sition before releasing it.
7. Slowly return the throttle grip to the fully
closed position.
TIP:
When the engine is cold, it needs to be
G
warmed up. For further information, see
page 44.
If the engine does not start on the first try,
G
repeat the procedure. If the engine fails to
start after 4 or 5 tries, open the throttle a
small amount (between 1/8 and 1/4) and
try again. Also if the engine is warm and
fails to start, open the throttle a same
amount and try to start the engine again. If
the engine still fails to start, see page 71.
EMU27595
Electric start / prime start models
EWM01840
WARNING
Failure to attached engine shut-off cord
G
could result in a runaway boat if opera-
tor is ejected. Attach the engine shut-
off cord to a secure place on your cloth-
ing, or your arm or leg while operating.
Do not attach the cord to clothing that
ZMU03279
could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-
G
ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1. Place the gear shift lever in neutral.
TIP:
The start-in-gear protection device prevents
the engine from starting except when in neu-
tral.
2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
Operation
41