Windows Storeall Clients; Synchronizing Information On File Serving Nodes And The Configuration Database - HP StoreAll 9730 Administrator's Manual

Windows StoreAll clients

Logged in but getting a "Permission Denied" message
The StoreAll client cannot access the Active Directory server because the domain name was not
specified. Reconfigure the Active Directory settings, specifying the domain name. See the
StoreAll Storage Installation Guide
Verify button in the Active Directory Settings tab does not work
This issue has the same cause as the above issue.
Mounted drive does not appear in Windows Explorer
To make a drive appear in Explorer, after mounting it, log off and then log back on, or reboot the
machine. You can also open a MS-DOS command window and access the drive manually.
Mounted drive not visible when using Terminal Server
Refresh the browser's view of the system by logging off and then logging back on.
StoreAll client auto-startup interferes with debugging
The StoreAll client is set to start automatically, which can interfere with debugging a Windows
StoreAll client problem. To prevent this, reboot the machine in safe mode and change the Windows
StoreAll client service mode to manual, which enables you to reboot without starting the client.
1. Open the Services control manager (Control Panel > Administrative Tools > Services).
2. Right-click StoreAll client Services and select Properties.
3. Change the startup type to Manual, and then click OK.
4. Debug the client problem. When finished, switch the Windows StoreAll client service back to
automatic startup at boot time by repeating these steps and changing the startup type to
Automatic.
Synchronizing information on file serving nodes and the configuration
database
To maintain access to a file system, file serving nodes must have current information about the file
system. HP recommends that you execute ibrix_health on a regular basis to monitor the health
of this information. If the information becomes outdated on a file serving node, execute ibrix_dbck
-o to resynchronize the server's information with the configuration database. For information on
ibrix_health, see
NOTE: The ibrix_dbck command should be used only under the direction of HP Support.
To run a health check on a file serving node, use the following command:
ibrix_health -i -h HOSTLIST
If the last line of the output reports Passed, the file system information on the file serving node
and Fusion Manager is consistent.
To repair file serving node information, use the following command:
ibrix_dbck -o -f FSNAME [-h HOSTLIST]
To repair information on all file serving nodes, omit the -h HOSTLIST argument.
for more information.
"Monitoring cluster health" (page

Synchronizing information on file serving nodes and the configuration database

104).
HP
151