Brother DCP-J172W User Manual page 44

e
Each colour has its own correct position.
Insert the ink cartridge in the direction of
the arrow on the label.
f
Gently push the back of the ink
cartridge—marked PUSH— until the
cartridge lever lifts, and then close the
ink cartridge cover.
g
The machine will automatically reset the
ink dot counter.
36
NOTE
• If you replaced an ink cartridge, for
example Black, the Touchscreen may ask
you to verify that it is a brand new one (for
example, Did You Change
For each new cartridge you installed,
press Yes to reset the ink dot counter for
that colour. If the ink cartridge you
installed is not a brand new one, be sure
to press No.
• If the Touchscreen shows
No Ink Cartridge or
Cannot Detect after you install the ink
cartridge, check that the ink cartridge is a
brand new Brother Original cartridge and
that it is installed correctly. Remove the
ink cartridge and reinstall it slowly and
firmly until the cartridge lever lifts.
IMPORTANT
• DO NOT take out ink cartridges if you do
not need to replace them. If you do so, it
may reduce the ink quantity and the
machine will not know the quantity of ink
left in the cartridge.
• DO NOT touch the cartridge insertion slots.
If you do so, the ink may stain your skin.
• DO NOT shake the ink cartridges. If ink
gets on your skin or clothing, immediately
wash it off with soap or detergent.
• If you mix the colours by installing an ink
cartridge in the wrong position, the
Touchscreen shows
Wrong Ink Colour. Check which ink
cartridges are not matched by colour to
their ink cartridge positions and move
them to their correct positions.
• Once you open an ink cartridge, install it in
the machine and use it up within six
months of installation. Use unopened ink
cartridges by the expiration date written on
the cartridge package.
• DO NOT dismantle or tamper with the ink
cartridge; this can cause the ink to leak out
of the cartridge.
Black).