Cooling System Cleaning; Spark Arrestor Muffler; Spark Arrestor Screen - Echo CS-450P Instruction Manual

Hide thumbs Also See for CS-450P:

Table of Contents

MAINTENANCE

Some tree sap and resins are corrosive. Thoroughly wash the guide bar and sprocket areas after each use,

then coat metal parts with light oil.

Cooling System Cleaning

• Check periodically.

• Clogged fins will result in poor engine cooling.

1. Remove air cleaner cover, cylinder cover, and starter.

2. Use compressed air or wooden tool to remove dirt and

dust from between fins to let cooling air pass easily.

• The spark arrestor muffler controls the exhaust noise and prevents hot, glowing particles of carbon from

leaving the muffler.

• Make sure the spark arrestor screen is in good repair and properly seated in the muffler.

• Certain internal combustion engines operated on forest, brush, and/or grass-covered areas in the states of

Washington, Oregon, Idaho, California, Minnesota, New Jersey and Maine, are required to be equipped

with a spark arrestor.

This requirement also applies to all U.S. Forest Service lands. In some of these areas, the spark arrestor

system must be certified per USDA Forest Service Regulation SAE J335.

Check with your local or state authorities for specific regulations in your area. Failure to follow these

requirements is a violation of the law.

Carbon deposits in muffler will cause drop in engine output and

overheating. Spark arrestor screen must be checked

periodically.

1. Remove air cleaner cover and remove spark plug lead.

2. Remove spark arrestor cover (C) and screen (B) from

muffler (A) body.

3. Clean carbon deposits from muffler components.

4. Replace screen if it is cracked, or has holes burned through. Inspect gasket (D), replace if damaged.

5. Assemble components in reverse order.

Note: When cleaning carbon deposit, be careful not to damage the catalytic element inside muffler.

CS-450P

Cylinder fins

X7503197606

Table of Contents