Warning Leds And Symbols - Electrolux ENV06 Service Manual

3.12 Warning LEDs and symbols

L1 or
Clean heat exchanger:
Lights after 80 drying cycles.
To reset the cycle counter (for this function), open
the access panel while the dryer is switched on,
remove and clean the heat exchanger. Replace the
heat exchanger and close the access panel.
L2 or
Clean filter
Lights at the end of the drying cycle to warn the user
that the filter requires cleaning.
L3 or
Canister full
Lights during the course of the drying cycle if the
electronic control system detects that the floating
microswitch has closed or at the end of the cycle, to
indicate to the user that the canister must be
emptied.
L4 Start / Pause
Flashes (green) when the cycle is in pause mode, or
lights green (fixed) while the cycle is being
performed. If any of the alarm conditions has been
detected, the buzzer will sound three "beeps" twice
within a few seconds, and this LED will begin to
flash (red).
2008-03 ADL 14/58 599 70 66 79