KX-TGH260/KX-TGH262/KX-TGH263/KX-TGH264/KX-TGHA20/KX-TGA20
8 Test Mode
8.1.
Engineering Mode
8.1.1.
Base Unit
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you m ay ruin the unit.
Make sure the link between Base and Handset before that. Then in case using not original Handset,
you need to deregister Handset.
Note: Refer to Registering a Handset to a Base Unit in the Operating Instructions.
Dial keypad
1). Press
2). Select "Settings" using
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
4). Select "Write EEP" using
5). Enter " ", " ", " ", " " (Address). (*1)
6). Enter " ", " " (New Data). (*1)
{OFF}
{FLASH}
{CALL WAIT}
H/S key operation
{
}
MENU
.
{^}
{
}
then press
SELECT
or
Select "Set tel line" using
{
}
then press
SELECT
or
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
{
}
then press
SELECT
or
{V}
or
{>}
.
{^} {V}
or
{>}
.(*)
{^} {V}
or
{>}
.
26
This pictured model is KX-TGH260
H/S LCD
Service Mode
Read EEP
Write EEP
BACK
SELECT
Set Addr.:
Default Data
CLEAR
OK