Table of Contents
Advertisement
If you want to use your remote control with the cable, connect one end of the cable to
the jack on the remote control and the other end to the Terminal Panel.
1. Mouse Button Works as a mouse for your projected computer image. This button
is also used to adjust position, zoom and focus.
2. Position Button When you're in the 2X or 4X mode, hold this button down and
adjust the picture position up and down or left and right with the mouse pad.
3. Zoom Button Hold this button down and adjust the picture size (zoom in or out)
with the mouse pad.
4. Focus Button Hold this button down and adjust the focus with the mouse pad.
5. 2X/4X Button Pressing this button will enable you to toggle between a standard
image, a double-sized (2X) image and a quadrupled image (4X).
6. RGB Button Press to select an RGB video source from a computer or document
camera.
7. S-Video Button Press to select an S-Video source from a VCR.
8. Video Button Press to select an NTSC, PAL, SECAM or M-NTSC compatible
video source from a VCR or laser disc player.
9. Freeze Button This button will freeze a picture.
10. Menu ButtonUse this button to call up the menu of icons to adjust and set the image.
11. Select ButtonMake your on-screen menu selections for adjusting and setting the
image with this button. (See page 35.)
3. Remove the two screws securing the lamp case. (There is an interlock on
this case to prevent the risk of electrical shock. Do not attempt to
circumvent this interlock.)
4. Use the lamp case handle to remove the assembly.
5. Install a new lamp case assembly and secure it in place with the two
screws.
CAUTION: Do not use lamps other than the NEC optional lamp.
Order by your projection's model number.
6. Reattach the lamp cover and reinstall the single screw.
7. After you install a new lamp, select the Lamp Usage icon and press and
hold the "Power On" button on the remote control for ten seconds to
reset the lamp time clock to zero.
NOTE: When you replace the lamp, it is also wise to replace the filter. The
filter comes in the same package with your replacement lamp. Contact your
NEC dealer for replacement lamps. Order by your projector's model number.
CAUTION: Do not put the LCD projector on end except for lamp and/
or air filter replacement.
MAINTENANCE
Remote Jack
Insert the supplied
remote cable here.
Left click button*
21
Step 4
Step 5
Step 6
42
Advertisement
Table of Contents
