Inserting The Water Filter - Cuisinart DGB-1 Instruction Booklet

Single cup grind & brew coffeemaker
Hide thumbs Also See for DGB-1:
Table of Contents

Advertisement

Available languages

Available languages

11. Filter Basket Cover
Cover becomes hot after coffee is
brewed. Use caution when removing
cover. NOTE: Cover must be in place
for unit to operate correctly.
12. Gold Tone Filter
Position handle toward front of unit so
it does not interfere with the flow of
coffee into the filter basket. Our
permanent filter may allow some fine
coffee grounds to flow through, which
can appear as sediment in your cup.
10a
10b

INSERTING THE WATER FILTER

Your coffeemaker comes with a charcoal water
filter that eliminates chlorine, bad tastes and
odors from tap water.
• Remove the filter from polybag and soak it,
fully immersed, in cold tap water for 15 minutes.
• Lift the water filter holder out of the water
reservoir.
• Press down on the filter compartment and pull
toward you to open.
• Place filter into the holder and snap it closed.
Be careful – improper placement can tear the
filter skin.
• Flush filter by running cold tap water through
holes in bottom of compartment for 10 seconds.
13. Filter Basket
Holds #2 paper filter or Cuisinart
permanent gold-tone filter. NOTE:
Filter basket must be in place for unit
to operate correctly.
14. Filter Basket Holder
Reach under and pull out to access
filter, filter basket and cover.
9
14
• Allow the filter to drain completely.
• Slide the water filter holder back into the
channel in the water reservoir, pushing it down
to the base of the unit.
NOTE: We
recommend changing
the water filter every
60 days or after 60
uses, and more often
if you have hard
water. Replacement
filters can be
purchased in stores,
or by calling Cuisinart
customer service, or
at www.cuisinart.com.
5
Coffeemaker Charcoal
Water Filter
11
12
13

Advertisement

Chapters

Table of Contents
loading

Table of Contents