Panasonic Viera TX-P42VT20E Operating Instructions Manual page 5

Warning
Do not disassemble or modify the pedestal.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any other TV and displays.
●
Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
●
If you use the pedestal while it is physically damaged, personal injury may result. Contact your nearest Panasonic
dealer immediately.
During set-up, make sure that all screws are securely tightened.
●
If insufficient care is taken to ensure screws are properly tightened during assembly, the pedestal will not be
strong enough to support the TV, and it might fall over and become damaged, and personal injury may result.
Ensure that the TV does not fall over.
●
If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal
injury may result.
Two or more people are required to install and remove the TV.
●
If two or more people are not present, the TV may be dropped, and personal injury may result.
When removing the pedestal from the TV, do not remove the pedestal by the methods other than the
specified procedure. (see below)
●
Otherwise the TV and / or pedestal may fall over and become damaged, and personal injury may result.
Assembly screw (3)
(silver)
M5 × 18
■
Assembling the pedestal
Use the assembly screws
the base securely.
●
Make sure that the screws are securely tightened.
●
Forcing the assembly screws the wrong way will strip
the threads.
■
Securing the TV
Use the assembly screws
●
Tighten the four assembly screws loosely at first,
then tighten them firmly to fix securely.
●
Carry out the work on a horizontal and level surface.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking the
TV.
Remove four assembly screws
Pull out the pedestal from the TV.
Remove three assembly screws
Attaching / removing the pedestal
Assembly screw (4)
(black)
M5 × 30
to fasten the pole to
to fasten securely.
from the TV.
from the pole.
Pole
●
TBLA3828
(TX-P42VT20E)
●
TBLA3834
(TX-P46VT20E)
D
B
Hole for pedestal
installation
(View from the bottom)
Base
●
TBLX0184
(TX-P42VT20E)
●
TBLX0155
(TX-P46VT20E)
A
Front
Arrow mark
D
5