Panasonic Viera TX-P42VT20E Operating Instructions Manual page 16

Viewing 3D images
■
Replacing the battery
When the battery is running low, the indicator lamp flashes 5 times on turning the 3D Eyewear on. In this case,
early battery replacement is recommended.
●
Dispose of the old batteries as non-burnable rubbish, or in line with the waste disposal regulations in your local
area.
Loosen the screw and remove the battery cover using the supplied screwdriver
Replace the battery
Replace and fasten the battery cover
■
Attaching the nose pad
Use either nose pad A or B for your preference.
●
If you put the 3D Eyewear on vision correction glasses, the nose pad is recommended to be removed.
■
Attaching the specialised band
If the 3D Eyewear slips out of place, use the supplied specialised band to hold it in place.
●
Attach the band to the left and right tips of the frame, and adjust the length.
Specialised band
Frame
When the end of the specialised band is straightened, form a loop at the end of the band, and fix the twisted
part.
■
Storing and cleaning the 3D Eyewear
●
Use the supplied 3D Eyewear case to store the 3D Eyewear.
●
Avoid storing the 3D Eyewear in hot or highly humid locations.
●
Use a clean, soft and dry cloth to wipe the 3D Eyewear. Otherwise, dirt or dust may scratch the eyewear.
●
Do not use benzene, thinner, or wax on the 3D Eyewear, as doing so may cause the paint to peel off.
●
Do not submerge the 3D Eyewear in liquid such as water when cleaning.
16
Screwdriver
(supplied)
Battery cover
●
Use the specified type of battery (coin-shaped lithium battery CR2032).
●
Note the correct polarity (+ or -).
●
Make sure that the screw is tightened.
Battery cover
●
You can select the positions of the nose pad A from the 2 levels
of height. Use upper 2 protrusions or lower 2 protrusions on the
Nose pad A
3D Eyewear to attach the nose pad A.
●
Use all 3 protrusions on the 3D Eyewear to attach the nose pad B.
or
Nose pad B
Push to adjust the
length of the band
Fix the
twisted part
●
Treat the rubber part carefully not to break it.