Wiring Diagram - NEC MT1056 User Manual

Wiring Diagram

MOUSE
PC CONTROL
OUTPUT
RGB MONITOR
AUDIO OUTPUT
AUDIO RGB INPUT 1
AUDIO RGB INPUT 2
S-VIDEO
L / MONO
To video, S-video, and audio
inputs on the projector.
VCR, DVD Player or LaserDisc Player
NOTE: When using with a notebook PC, be sure to connect between the projec-
tor and the notebook PC before turning on the power to the notebook PC. In
most cases signal cannot be output from RGB output unless the notebook PC
is turned on after connecting with the projector.
NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8
feet) or shorter.
Supplied serial cable
REMOTE
CONTROL
INPUT
Optional 15-pin-to-RCA
(female) 3 cable
(ADP-CV1)
R
VIDEO
Monitor
Supplied mouse adapter
(For USB)
Supplied mouse adapter
(For IBM PS/2 or USB)
Signal cable (supplied)
To mini D-Sub 15-pin connector on the projector.
It is recommended that you use a commercially
available distribution amplifier if connecting a sig-
nal cable longer than the one supplied.
Component video cable
RCA 3 (not supplied)
Remote Control Guideline
1. Plug the supplied serial cable with the mouse output port of the pro-
jector into your computer's mouse port and restart your computer to
gain remote mouse control.
2. When using the remote control's built-in infrared mouse on a laptop
computer, the laptop's mouse, trackball or trackpad will be disabled.
Disconnect the serial cable from the mouse output port and restart
your computer to regain trackball or trackpad mouse control.
3. If the screen goes blank while using your remote control, it may be
the result of the computer's screen-saver or power management
software.
4. If you accidentally hit the OFF button on the remote control, wait one
full minute and then press the ON button to resume.
E – 18
Macintosh or Compatibles
(Desktop type or notebook type)
IBM VGA or Compatibles
(Desktop type or notebook type)
DVD Player (with component output)
Document Camera