IBM L40 SX Quick Reference page 98

#4.3.4 Printer and Parallel Device Problems
+------------------------------------------------------------------------+
¦ PROBLEM ¦ ACTION
+--------------+---------------------------------------------------------¦
¦ The printer ¦ Note:
¦ does not ¦
¦ work. ¦
¦ ¦
¦ ¦
¦ ¦
¦ ¦
¦ ¦ Check to see that:
¦ ¦
¦ ¦ 1. The printer is turned on and is online.
¦ ¦
¦ ¦ 2. The printer signal cable is plugged into the
¦ ¦ parallel connector on the computer.
¦ ¦ location of the parallel connector, see page 2.4.
¦ ¦
¦ ¦ 3. The Onboard Serial power option of the Set Features ¦
¦ ¦ Menu is set to On if the printer is connected to
¦ ¦ the serial connector.
¦ ¦
¦ ¦ 4. The Onboard Parallel power option of the Set
¦ ¦ Features Menu is set to On if the printer is
¦ ¦ connected to the parallel connector.
¦ ¦
¦ ¦ If the above items are correct and the printer still
¦ ¦ does not work, run the tests described in the printer
¦ ¦ manual.
¦ ¦ system serviced.
+--------------+---------------------------------------------------------¦
¦ The parallel ¦ Take the same actions as you do in The printer does not ¦
¦ device does ¦ work.
¦ not work. ¦
¦ ¦ If the parallel device still does not work, see
¦ ¦ "Parallel Connector Setup Program" in topic E.5 because ¦
¦ ¦ some parallel devices do not work when the parallel
¦ ¦ connector of the Model L40 SX is in extended mode that
¦ ¦ allows bidirectional input and output.
+------------------------------------------------------------------------+
PS/2 Model L40 SX Quick Reference
Printer and Parallel Device Problems
If the computer enters suspend mode while the
printer is printing out any data, the printer
may not print out the data as you expected after ¦
returning to resume mode.
with the printer. See "Attached Devices" on
page 3.5.2.1.
If the tests show the printer is OK, have the
¦ Copyright IBM Corp. 1991
4.3.4 - 1
¦
¦
¦
This is not a problem ¦
¦
¦
¦
¦
¦
¦
¦
¦
For the ¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦